Machine tool of HL line cut controls version of V5.16 of process designing system to add function and service instruction newly

Taper mode increased " sway guide pulley " mode, this function undertook when treatment auger spends radian of cut Y direction to amend, make HL OK cut auger was spent.

Cut taper is 45 ° , filar wearing is 2 meters high, also can assure cut precision.

Not only such, general small taper and common " sway procrastinate board " the cut precision of mode also rises accordingly.

2.

The short circuit voltage that frequency conversion dogs is more reasonable, adjust what percentage divides is finer, make handlers easier adjust frequency conversion dogs, make machine efficiency to rise apparently at the same time, especially thick to cutting or exceed thick.

3.

The DXF file changeover of AUTOCADR12 is more reliable, the line segment that rotates to coordinate won't be lost again.

4.

Picture color can be adjusted by him user, make HL is single black picture no longer.

The user can be in " systematic parameter " inside the setting " Colors is installed " color of picture of one column change.

5.

USBU dish use: ? Mo of astounded of fawn on of Qian of alkyne of Qu  postscript dish, the system starts when entering CONFIG to choose, choose 2.

USB can, after entering HL, in " the file transfers into " in can see U:WThe existence of SNCP.

6.

Can HL system also move: below WINDOWS98 system? Let down with a rope of male of astounded of let down with a rope slaughters dam Xiao INDOWS98 system, but advanced WIN98, run HLv5 again next.

16.

And the tripartite software that can run WIN98 platform in cut process.

Concrete move is as follows: A.

When moving first, in the picture of the first choice when HL is started, choice " 1-RUN moves " , after entering HL normally, by [ESC] key exits DOS to fall, the command goes under clavier input: ≫COPYC:CONFIG.

WIND:CONFIG.

SYS>COPYC:*.

*D:WSNCP restarts computer.

B.

In the picture of the first choice when HL is started, choose " 2-USED: ? After otter? system starts the WIN98 system that enters an user, can be in C:WFind in SNCP " quick HL " or " HL_WIN " icon, doubleclick this icon can, the user also can be built by oneself " HL_WIN " quick way arrives WIN98 desktop.

C.

In the process of moving HL, the user cannot issue switch to arrive with the graphical mode in HL WIN98, HL is exited in also cannot undertaking with be being machined, such meetings are in additionally the treatment that have does not go (high frequency and ceaseless) , but the user can arrive in the switch below text mode WIN98, in HL advocate the choice in the picture " [3B] is inputted " or " Edit input edits " can make HL enters text mode.

7.

HLv5.

The network version of 16 already took AUTOP at the same time, need downloads and install P20 no longer.

EXE arrives on the computer of the user or server.

CNC Milling